| 1. Establish the selector in the situation "R". |
|
2. Unscrew a bolt–2–at a forward support–1–cables of the selector. |
3. Establish the selector-4-in the situation "R", having pressed it to a back emphasis. Blocking of a parking should be fixed, at the released parking brake the car should not move.
ATTENTION
Do not remove a lock bracket.
|
| 4. Displace a selector cable at a bolt–2–so that it was not tense. In this situation tighten a bolt–2 – the moment of 5 N · m. |
| 5. In summary check adjustment by the image described below. |
| Adjustment check |
| 6. Transfer the selector to the situation "R" at the pressed lock key in the handle approximately on 5 mm back and release. The selector should return to a starting position independently. |
| 7. Transfer the selector to the situation "N" at the pressed lock key in the handle approximately on 5 mm forward and release. The selector should return to a starting position independently. |
| 8. If the selector is not fixed, repeat adjustment. |
| 9. Pass on the car and check operation of the selector. The engine should be started only in position of the R or N selector. |
| 10. Include ignition. At the standing car the selector should have possibility to leave only from the situation "R" or "N" if the brake pedal is at the same time pressed. |
| Adjustment of a cable of blocking of switching |
| 11. Establish the selector in situation "1". |
| 12. Remove covers of a steering column. |
| 13. Turn the ignition key in the situation "Start" and release. Check a gap between the lever of a cable and a lock finger of the lock. It should make 0.7 mm. |
| 14. For adjustment weaken a tightening nut of a cable and arrange the cable lever for achievement of a demanded gap. |
|
15. Tighten a tightening nut. |
| 16. Tighten bolts of the case of the switch and establish covers of a steering column. |
| Adjustment of an electromagnet of blocking of switching |
| 17. Establish the selector in the situation "N" or "R". |
| 18. Weaken bolts of fastening of an electromagnet. |
|
19. Establish щуп 0.3 mm between a pusher of an electromagnet and the lever. |
| 20. If it is required shift an electromagnet and tighten bolts of its fastening. |
