The device, service, Audi A3 repair (c of 1997 of release) - Removal and radiator and fan installation//A3 Audi artistwave.ru

Audi A3

since 1997 of release

Repair and car operation



Audi A3
+ Maintenance instruction
+ Current leaving and service
+ Engine
- Systems of cooling, heating
   - System of cooling of the engine
      Antifreeze – means of protection from freezing
      Replacement of cooling liquid
      Removal, installation and thermostat check
      Removal and radiator and fan installation
      Removal and installation of the pump of cooling liquid
      Check of system of cooling under pressure
      Check of a thermoswitch of the fan of cooling
   + Systems of ventilation, heating and air conditioning
+ the Power supply system and production of the fulfilled gases
+ engine Electric equipment
+ Manual box of gear shifting
+ Automatic transmission and models with a full drive
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Elektroskhema







Removal and radiator and fan installation

REMOVAL

PERFORMANCE ORDER
1. Disconnect a negative cable (–) the storage battery at the switched-off ignition.

ATTENTION

Thereof information from electronic blocks of memory, as, for example, a radio receiver code is erased. Without a code the radio receiver can be included only by the manufacturer or HUNDRED AUDIS. Therefore familiarize with data in subsection Input of a code of a radio receiver.


2. Remove a front bumper, thus address to the subsection Removal and installation of bumpers.
3. Merge cooling liquid.
4. Disconnect from a radiator hoses for what remove sideways clips.
5. Rasstykuyte I will corrode the thermostat (at a radiator) and the fan.
6. Turn out bolts of fastening–1–bumpers from both parties of the car.
7. Weaken bolts of fastening–2–from both parties, without turning out them.
Specially for cars with the conditioner:

ATTENTION

It is not necessary to open a contour of cooling of the conditioner. Liquid hit on skin can cause frostbite.

It is not necessary to overwind, compress or bend pipelines and conditioner hoses.


8. Unscrew bolts of fastening–4–and remove the condenser from a radiator, thus address to an accompanying illustration.
9. Fix the condenser on a body (suspend) so that not to load pipelines/hoses of system of cooling.
All cars:
10. Turn out 4 bolts of fastening–3–radiators. Lower a radiator with the fan down.
INSTALLATION
11. If new details are established, fix them as follows:
12. Holder of the fan moment of 10 N of m, bolts–1–.
13. A thermoswitch–2 – the moment of 35 N of m.
14. Holders–3–and–4–put on a radiator.
15. Establish a radiator by means of the assistant and fix the moment of 10 N of m.
16. Cars with the conditioner: Fix the condenser the moment of 10 N of m.
17. Establish the forward panel, thus address to the subsection Removal and installation of the panel of the lock of a cowl.
18. Join the thermoswitch and fan socket.
19. Put on hoses of system of cooling on a radiator with new sealing rings and fix clips.
20. Establish a front bumper, thus address to the subsection Removal and installation of bumpers.
21. Attach a negative cable (–) to a battery battery room.

ATTENTION

Make active automatic equipment of safety of window regulators, enter a radio receiver code, establish hours, thus address to subsection Input of a code of a radio receiver.


22. Fill system with cooling liquid, thus address to subsection Replacement of cooling liquid.