Audi A3

since 1997 of release

GENERAL INFORMATION

To removal of a front bumper

1–bumper facing
2–bolt, 25 N • m
3–bolt of six-sided, 6 N • m
4–bumper
5–a directing element

6–саморез, 1.5 N • m
7–buffer
8–clip
9–the screw with a crosswise shliyets

Elements of a rear bumper

1–peak
2–саморез
3–cover
4–bumper facing
5–nut, 23 N • m

6–bumper
7–a directing element
8–саморез, 1.5 N • m
9–amplifier
10-саморез, 1 N • m

Front bumper

REMOVAL

PERFORMANCE ORDER

1. Press through a thin pin an insert (the shooter on an illustration) on a clip–8–and take out it.
2. Turn out on three Torx screws (T25) on a wheel casing at the left and on the right.
3. Turn out screws with a crosswise shliyets – 9–from the bottom party.
4. Disconnect bumper facing above at a directing element-5-.
5. Disconnect bumper facing sideways over wheel casings and remove forward from a bumper.
	6. Turn out bolts of fastening of-2-support–1–bumpers–3–.
	7. Turn out screws with an internal shestigrannik – 5–on both shock-absorbers-1-.
8. Take out a bumper–4–of the shock-absorber and remove it forward.

INSTALLATION

PERFORMANCE ORDER

1. Put on a bumper–4–shock-absorbers-1-.
2. Screw screws with an internal shestigrannik – 5–and tighten the moment of 23 N • m.
	3. Tighten bolts of fastening of-2-support of a bumper the moment of 6 N • m, address to an illustration.
4. Establish in front facing–1–(address to an illustration To removal of a front bumper) and correct it sideways over wheel casings.
5. Fix bumper facing in a directing element-5-.
6. Tighten from the bottom party screws with a crosswise shliyets.
7. Fix bumper facing at the left and on the right three Torx c screws of each party to loker of arches of wheels.
8. Insert clips–8–into openings above at facing of a bumper and press pins (shooter) so that they completely entered into a clip, address to a fragment on an illustration To removal of a front bumper.

Rear bumper

REMOVAL

PERFORMANCE ORDER

1. Remove slips–1–at the left and on the right for what turn on саморезы.
2. Uncover–3–.
3. Unscrew саморезы fastenings of the amplifier-10-and remove the amplifier-9-.
4. Turn out at the left and on the right at wheel casings on 3 самореза.
5. Take out facing of a bumper–4–from above from a directing element-7-.
6. Hook bumper facing sideways over loker of arches of wheels and remove back.
7. Unscrew nuts–5–and remove a bumper–6–.

INSTALLATION

PERFORMANCE ORDER

1. Establish into place a bumper and fix it nuts–5–.
2. Correct facing of a bumper–4–sideways over wheel casings and insert from above into directing element-7-.
3. Screw at the left and on the right in loker of arches of wheels on 3 самореза.
4. Put the amplifier-9-and fix it саморезами–10–.
5. Put a cover–3–.
6. Establish slips–1–at the left and on the right and fix them саморезами–2–.