Audi A3
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ the Power supply system and production of the fulfilled gases
+ engine Electric equipment
+ Manual box of gear shifting
+ Automatic transmission and models with a full drive
+ Coupling and power shafts
- Brake system
Replacement of forward brake shoes
Removal and installation of disk brake mechanisms of back wheels
Check of thickness of a brake disk
Removal and installation of a brake disk/support
Adjustment of the parking brake
Brake liquid
Air removal from brake system
Removal and installation of a brake hose
Check of the amplifier of a brake
Removal, installation and adjustment of the switch of a stoplight
Removal and installation of the lever and cable of the parking brake
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Elektroskhema
|
Removal and installation of the lever and cable of the parking brake
The lever of the parking brake with fastening elements
1–lever of the parking brake
Before removal remove the central console.
2–lock washer
3–facing of the lever of the parking brake. Acts in film forward
4–nut, 25 N • m
5–adapter. For cars with the central armrest
6–draft | 7–equalizer
8–adjusting nut
9–support finger
10-cable of the parking brake
11-switch of control of the parking brake | CABLE REMOVAL Cars with a forward drive
| PERFORMANCE ORDER |
| 1. Remove the back central console, thus address to the subsection Removal and pocket installation from the driver. | | 2. Release the parking brake. | | 3. Unscrew an adjusting nut so that the cable could be removed from the equalizer. Disconnect a cable of the parking brake. | | 4. Disconnect a cable of the parking brake at a support, thus address to the subsection Removal and installation of disk brake mechanisms of back wheels. | | 5. Mark paint the provision of back wheels concerning naves. It will allow to establish at assembly an otbalansirovanny wheel in its former situation. Weaken bolts of fastening of a wheel on the car standing on the earth. Lift a back part of the car, put it on supports and remove back wheels. | | 6. Disconnect a cable from the holder (And) at a beam of a back suspension bracket and remove from holders. |
| 7. Disconnect a cable from the holder (And) at a beam of a back suspension bracket and remove from holders | | 8. Take out a cable. |
| INSTALLATION
|
|
