Audi A3

since 1997 of release

Repair and car operation



Audi A3
+ Maintenance instruction
+ Current leaving and service
+ Engine
- Systems of cooling, heating
   + System of cooling of the engine
   - Systems of ventilation, heating and air conditioning
      General information and security measures
      Removal and installation of air deflectors
      Removal and installation of a nozzle of the region of feet
      Removal and drive installation lamp heater/replacement
      Removal and installation of cables of a drive of management of a heater
      Removal and installation of the fan of fresh air
      Removal and installation of the additional resistor
      Conditioner
      Removal and compressor installation
      Conditioner diagnostics on codes on the display of the block of its management
+ the Power supply system and production of the fulfilled gases
+ engine Electric equipment
+ Manual box of gear shifting
+ Automatic transmission and models with a full drive
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Elektroskhema







Removal and installation of cables of a drive of management of a heater

REMOVAL

PERFORMANCE ORDER
1. Remove a heater drive.
2. Disconnect a support of drafts (And).
3. Disconnect drafts (In) at a heater drive.
4. Remove a nozzle of the region of feet, address to the subsection Removal and installation of a nozzle of the region of feet.
5. Hook a screw-driver and remove brackets (And) support of a drive of a heater on a heater casing.
6. Carefully remove drafts from levers (In) and (C).
INSTALLATION
7. Before installation check drafts of a heater on ease of a course. In the presence of jammings or damages of draft replace.

ATTENTION

At assembly of draft of a heater fix collars and clips so that they did not concern mobile parts.


Connection of cables with the heater control panel
8. Connect cables (In) so that the winding was turned down.
9. Connect a green cable (And) zaslonka of a nozzle of defrosting of glasses/region of feet to the lever of a drive of a heater. Fix a support.
10. Connect a yellow cable (In) zaslonka of a nozzle of defrosting of glasses to the lever of a drive of a heater. Fix a support.
11. Connect a brown cable (C) zaslonka of a nozzle of defrosting of glasses to the lever of a drive of a heater. Fix a support.
12. Establish a heater drive.
Connection of cables with the heater case
13. Connect a green cable (And) to the lever of a zaslonka of a nozzle of defrosting of glasses/region of feet. A support yet do not fix.
14. Connect a yellow cable (In) to the lever of the central zaslonka.
15. Connect a brown cable (C) to the lever of a temperature zaslonka.
Adjustment of drafts of a heater
16. Turn the handle of a choice of temperature against the stop in the situation "kalt" ("cold").
17. Slightly press the lever (In) on a heater box in the arrow direction. In this situation fix draft on a support a bracket (And).
18. Turn the handle of the distributor of air against the stop in the provision of distribution of air to a windscreen.
19. Slightly press the lever (C) the central zaslonka in the arrow direction, address to an illustration in point 17. In this situation fix draft on a support a bracket (And).
20. Press the lever (In) zaslonka of defrosting of glasses/region of feet in the direction of an arrow and fix draft on a support a bracket (And).
21. Turn in different directions both handles between an extreme emphasis, they should concern both emphasis.
22. Remove a nozzle of the region of feet, address to the subsection Removal and installation of a nozzle of the region of feet.