Audi A3

since 1997 of release

Repair and car operation

Audi A3
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ the Power supply system and production of the fulfilled gases
+ engine Electric equipment
- Manual box of gear shifting
   Removal and RKPP installation
   Gear shifting drive
   Removal and installation of the case of the mechanism of a choice of transfers
   Adjustment of a drive of switching
+ Automatic transmission and models with a full drive
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Elektroskhema

Removal and installation of the case of the mechanism of a choice of transfers

GENERAL INFORMATION

The lever of gear shifting is located in the case of the mechanism of a choice of transfers. Before replacement of cables of a drive of switching it is necessary to remove the case specified above.

REMOVAL

PERFORMANCE ORDER

1. Engines of 1.8 l: Remove cables of a drive of a choice of transfer a support at RKPP, thus address to the subsection Removal, installation and coupling check.
	2. Remove upward a cover of the lever of switching (an arrow on an illustration) and remove it via the handle.
	3. Weaken a collar (the shooter on an illustration) and remove the handle together with a cover.
4. Take out at cut of the lever of switching a noise quencher.
5. Separate release system between a reception pipe and the central exhaust silencer. Unscrew bolts and lower a cross-piece for exhaust silencer fastening at the bottom, thus address to the subsection Removal and installation of system of release.
6. Unscrew bolts of fastening and disconnect the heat-shielding screen under the gear shifting lever.
	7. Unscrew nuts (are specified by shooters) fastenings about the switching lever.
8. Unscrew from the bottom party of the car 2 bolts of fastening at the case of the mechanism of a choice of transfers.
9. Lower the case and take out completely with drafts back.

INSTALLATION

PERFORMANCE ORDER

1. Installation is carried out in sequence, return to removal. It is in addition necessary to mean the following.
2. If consolidation between the case and the bottom of the car is damaged, replace it.
3. Fix the case on the bottom the moment of 25 N of m.
4. Establish system of release and expose it, thus address to the subsection Removal and installation of system of release.
5. In summary adjust a switching drive, thus address to subsection Dismantling of a shaft of a drive.