Audi A3
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ the Power supply system and production of the fulfilled gases
+ engine Electric equipment
+ Manual box of gear shifting
+ Automatic transmission and models with a full drive
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
+ Forward suspension bracket
+ Back suspension bracket
- Steering
Removal and installation of the block of a safety cushion
Removal and installation of a steering wheel
Removal and installation helmsman of a draft/tip of steering draft
Removal and installation of the pump of the power steering
Corners of installation of forward wheels
+ Body
+ Onboard electric equipment
+ Elektroskhema
|
Removal and installation of the block of a safety cushion
ATTENTION
Before block removal a safety cushion surely take the appropriate measures of safety.
|
PERFORMANCE ORDER
|
1. Disconnect a negative cable (-)) the storage battery at the switched-off ignition.
ATTENTION
Thereof information from electronic blocks of memory, such as, a radio receiver code is erased. Without a code the radio receiver can be included only by the manufacturer or HUNDRED AUDIS. Therefore familiarize with instructions in the subsection Removal and installation of the storage battery and subsection Input of a code of a radio receiver.
|
| 2. Isolate a negative pole (-)) the storage battery thereby to exclude casual contact. |
| 3. Establish wheels directly, and a steering wheel in average situation. |
|
4. Turn out two Torx screws of fastening of the block of a safety cushion key Т30. |
| 5. Rasstykuyte I will corrode the safety cushion block. |
| 6. Remove the block and put aside the soft party up. |
| 7. Do not change the provision of a steering column (the direct provision of wheels). |
|
INSTALLATION
|
PERFORMANCE ORDER
|
| 1. Join the safety cushion socket. |
| 2. Establish a safety cushion on a steering wheel and fix the moment of 7 N • m. |
3. Include ignition, the ignition key should be in the situation "Movement".
ATTENTION
During connection of the storage battery do not leave people in car salon.
|
4. Attach a weight cable (-)) the storage battery.
ATTENTION
Make active automatic equipment of an electric window regulator, and also establish hours, being guided by the subsections Removal and installation of the storage battery and Input of a code of a radio receiver.
|
|
|
|
