Audi A3

since 1997 of release

Repair and car operation


Audi A3
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ the Power supply system and production of the fulfilled gases
+ engine Electric equipment
+ Manual box of gear shifting
+ Automatic transmission and models with a full drive
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Electric equipment of system of comfort
   Diagnostics of malfunctions of onboard electric equipment - the general information
   Check of the electric motor of a screen wiper
   Check of warmed back glass
   Stoplight check
   Removal, installation and check of a sound signal
   Safety locks
   Fusible inserts - the general information
   Chain breakers (thermal relays)
   Relay
   Replacement of batteries of a key of remote control
   Replacement of a battery/lamp of a natural with illumination
   Anticreeping blocking
   Lighting devices
   Replacement of lamps of external lighting
   Replacement of bulbs of internal lighting
   Removal and headlight installation
   Removal and installation of the electric motor of adjustment of range of light
   Removal and installation of the forward index of turn
   Removal and installation of a back lamp
   Adjustment of light of headlights
   Devices
   Removal and installation of a control panel
   Removal and installation of the podrulevy switch
   Removal and installation of switches and lamps
   Removal, installation and radio receiver coding
   Input of a code of a radio receiver
   Removal and loudspeaker installation
   Removal and installation of the aerial of a roof
   Additional installation of a radio telephone on in a special way prepared models
   Removal and installation of the electric motor of a forward screen wiper
   Removal and installation of the lever and electric motor of a back screen wiper
   Removal and installation of a cleaner of back glass
   Removal and tank installation with the pump of a stekloomyvatel
   Elements темпостата
+ Elektroskhema

38a8de3e

Removal and installation of a control panel
GENERAL INFORMATION

Sockets on a reverse side of a control panel
And – the socket 32 contacts, dark blue
In – the socket 32 contacts, green
With – the socket of 20 contacts, red. Only «Higline» execution
1–control lamp of a driving beam, 1.2 W		2–control lamp of antiprobuksovochny system ASR, 1.2 W (the additional equipment)
3–control lamp of the index of turn of the trailer, 1.2 W

In a control panel only control lamps which are filament lamps can be replaced. In the presence of any other malfunctions in the block it is necessary to replace it entirely.

If it is necessary to replace a control panel, before removal it is necessary to consider data from memory of malfunctions. Besides, by means of the diagnostic AUDI device can be считаны and values of the index of intervals of service and a condition of the counter of run (work HUNDRED) are written down.
ATTENTION

Removal of a steering wheel is not required. On the subsequent illustrations the steering wheel for the best review is not shown.

REMOVAL

PERFORMANCE ORDER
1. Completely extend a steering wheel with the mechanism of adjustment and displace it down.
2. Press sideways a cover–1–up and then extend a cover from the dashboard.
3. Turn out 2 screws with a crosswise shliyets – 1–.
4. Take out forward a combination of devices.
5. Cut a cable connector from a reverse side of a combination of devices.
6. Release stoppers of the tip and separate shtekerny connections from a reverse side of a combination of devices.
7. Replace the damaged lamps if it is possible.

INSTALLATION

PERFORMANCE ORDER
1. Installation is carried out in sequence, return to removal.
2. If the combination of devices was replaced, adjust the index of intervals of service and the counter of the passable distance (work HUNDRED).