Audi A3

since 1997 of release

Repair and car operation



Audi A3
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ the Power supply system and production of the fulfilled gases
+ engine Electric equipment
+ Manual box of gear shifting
+ Automatic transmission and models with a full drive
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Electric equipment of system of comfort
   Diagnostics of malfunctions of onboard electric equipment - the general information
   Check of the electric motor of a screen wiper
   Check of warmed back glass
   Stoplight check
   Removal, installation and check of a sound signal
   Safety locks
   Fusible inserts - the general information
   Chain breakers (thermal relays)
   Relay
   Replacement of batteries of a key of remote control
   Replacement of a battery/lamp of a natural with illumination
   Anticreeping blocking
   Lighting devices
   Replacement of lamps of external lighting
   Replacement of bulbs of internal lighting
   Removal and headlight installation
   Removal and installation of the electric motor of adjustment of range of light
   Removal and installation of the forward index of turn
   Removal and installation of a back lamp
   Adjustment of light of headlights
   Devices
   Removal and installation of a control panel
   Removal and installation of the podrulevy switch
   Removal and installation of switches and lamps
   Removal, installation and radio receiver coding
   Input of a code of a radio receiver
   Removal and loudspeaker installation
   Removal and installation of the aerial of a roof
   Additional installation of a radio telephone on in a special way prepared models
   Removal and installation of the electric motor of a forward screen wiper
   Removal and installation of the lever and electric motor of a back screen wiper
   Removal and installation of a cleaner of back glass
   Removal and tank installation with the pump of a stekloomyvatel
   Elements темпостата
+ Elektroskhema







Removal and installation of a cleaner of back glass

GENERAL INFORMATION

Cleaner of back glass

1–cover
2–nut, 15 N • m
3–lever
4–consolidation
5–jet
6–sealing ring
7–electric motor
8–nut, 8 N • m
9–rubber ring
10-remote element
11-brush

REMOVAL

PERFORMANCE ORDER
1. Cast away upward a cover.
2. Unscrew a nut–2–.
3. Cast away upward the lever and move sideways in different directions. Thus the lever acts in film from a cone of an axis of the electric motor.
4. Unscrew a nut and remove the lever.
5. Remove internal facing of a door of a back, thus address to the subsection Removal and installation of facing of a door of a back.
6. Rasstykuyte I will corrode – 1–and remove a hose–2–jets.
7. Unscrew bolts of fastening and remove the electric motor (are specified by shooters) (a key 10 mm).

INSTALLATION

PERFORMANCE ORDER
1. Carefully insert the electric motor through an opening in back glass. Thus watch the correct provision of consolidation, as is shown in an illustration.
2. Fix the electric motor the moment of 8 N • m.
3. Join the socket and put on a jet hose.
4. Establish internal facing of a door of a back, thus address to the subsection Removal and installation of facing of a door of a back.
5. Put on the lever an axis so that the distance and made 25 mm. The distance is measured from the bottom edge of glass to the bottom edge of a brush.
6. Fix the lever the moment of 15 N • m.
7. Cast away back a cover.