Audi A3
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ the Power supply system and production of the fulfilled gases
+ engine Electric equipment
+ Manual box of gear shifting
+ Automatic transmission and models with a full drive
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
Electric equipment of system of comfort
Diagnostics of malfunctions of onboard electric equipment - the general information
Check of the electric motor of a screen wiper
Check of warmed back glass
Stoplight check
Removal, installation and check of a sound signal
Safety locks
Fusible inserts - the general information
Chain breakers (thermal relays)
Relay
Replacement of batteries of a key of remote control
Replacement of a battery/lamp of a natural with illumination
Anticreeping blocking
Lighting devices
Replacement of lamps of external lighting
Replacement of bulbs of internal lighting
Removal and headlight installation
Removal and installation of the electric motor of adjustment of range of light
Removal and installation of the forward index of turn
Removal and installation of a back lamp
Adjustment of light of headlights
Devices
Removal and installation of a control panel
Removal and installation of the podrulevy switch
Removal and installation of switches and lamps
Removal, installation and radio receiver coding
Input of a code of a radio receiver
Removal and loudspeaker installation
Removal and installation of the aerial of a roof
Additional installation of a radio telephone on in a special way prepared models
Removal and installation of the electric motor of a forward screen wiper
Removal and installation of the lever and electric motor of a back screen wiper
Removal and installation of a cleaner of back glass
Removal and tank installation with the pump of a stekloomyvatel
Elements темпостата
+ Elektroskhema
|
Fusible inserts
Protection of some contours is carried out by inclusion in their electric chain of fusible inserts. Inserts are usually used for protection of contours not equipped with safety locks, such as an ignition contour.
Fusible inserts on these models are similar to safety locks in the sense that their exit out of operation (oplavleniye) easily is defined visually.
For replacement of a fusible insert at first disconnect a negative wire from the battery. Take burned-down insert and establish on its place new (can be acquired in representation office or shop of automobile accessories). Before insert replacement surely try to define the reason of the overload which has caused its exit out of operation.
|
|
