Audi A3

since 1997 of release

Repair and car operation

Supply of air via the channels intended for this purpose is regulated depending on the chosen control mode - automatically or manually.

On an illustration places of supply of the air, placed on the dashboard are shown.

On any of channels the heated-up, not heated up or cooled fresh air can arrive.

Management of distribution of air is carried out by the multiitem switch About (heater) or conditioner keys.

Stitched deflectors 3 and 4 can be closed or open the corrugated handles separately located on each side.
The direction of supply of air via stitched deflectors can be regulated both in vertical, and in horizontal the planes.
The conditioner automatically supports a uniform microclimate in all space of salon.

For this purpose the temperature of air arriving on stitched channels, and also its mass expense (quantity) and distribution of air streams automatically changes. In need of this automatic process it is possible to introduce manual amendments.

On the control panel display the conditioner established on the average console, deduces indication of the programmed temperature and fan turns. On the left side of the display there is a key of regulation of temperature, and from the right - a key of regulation of turns of the fan. Regulation of temperature and turns of the fan is carried out by pressing of keys “+” or “-”.

Governing bodies ventilation and heater

And temperature regulator

The temperature can be increased smoothly regulator rotation clockwise.

In the fan

Probably step four-regime regulation of a consumption of air.
Situation 0 corresponds to air interruption of supply.

About the air distributor

The direction of an air stream in space for feet

Stitched channels 5 are open.

For the direction of all stream of air to feet stitched deflectors 3 should be closed.

The direction of an air stream to a windscreen

Via deflectors 3 warm air on lateral glasses in addition can move.

Prevention of a zapotevaniye wind and lateral glasses

If at the increased humidity of air, for example, during a rain, glasses mist over, the following option of control of system is recommended:

Establish the switch B in situation II or III.

Regulator And if necessary slightly tighten with calling in a high-temperature range.

The air distributor C establish, depending on requirement, between provisions

Via deflectors 3 warm air on lateral glasses in addition can move.

The accelerated warming up of salon

The switch B in situation III.
The air distributor C in situation

Regulator And turn clockwise against the stop.
Open stitched deflectors 3.

Normal mode of heating of salon

When glasses will be cleared and in salon the necessary temperature will be established, it is recommended to adjust system as follows:

The switch B in situation II or III.

Regulator And adjust on the necessary productivity of a heater.
The air distributor C in situation

Stitched deflectors 3 are regulated at will.

Ventilation (mode of supply of fresh air)

In the option of control described below via stitched deflectors 3 and 4 not warm fresh air arrives:

The switch B establish in the necessary situation (III corresponds to the maximum intake of air).

Regulator And turn to the left against the stop.

The air distributor C in situation

Open stitched deflectors 3 and 4.

If necessary establish the air distributor C in other situation.

General provisions

For normal work of system of heating and ventilation the air inlet located before a windscreen should not be hammered by snow, ice and foliage.

In order to avoid a zapotevaniye of glasses on small speed the fan should be switched constantly on on low power.

For the termination of hit of the polluted external air in salon press a key D. In order to avoid a zapotevaniye of glasses movement in this mode should not be long-term.

The antidust filter catches the weighed microparticles of external air (for example, a dust, pollen etc.). Establish the switch in situation 0 only in case of pollution outwardly air gases.

Element of the antidust filter replace according to the plan THAT for the purpose of prevention of falling of capacity of a heater.

Governing bodies air conditioner

All modes of the conditioner will join and will be switched off by pressing of keys. At the included mode in the corresponding key the diode burns.

Standard control

After ignition inclusion:

Establish temperature 22°С (71°F) and press the AUTO key.
Such control provides the fastest creation in salon of a comfortable microclimate.

Therefore to recede from it there is a sense only if it is dictated by own health.

AUTO automatic equipment (regular mode)

The temperature, quantity and distribution of air are regulated automatically, by criterion of the fastest achievement and the subsequent maintenance of the necessary temperature in salon. Automatic response to fluctuations of temperature of external air, and also to sun influence is thus provided.

TEMP temperature regulation

The temperature in salon can be set in limits from 18°С (64°F) to 29°С (84°F). At regulator installation in one of the extreme provisions "LO" and "HI", regulations of temperature do not occur. The system constantly works in a mode maximum hlado-or heatproductivity.

Indication of temperature can be switched from Celsius scale to the Fahrenheit scale and back in the following order:

Press and hold a key

Then press a plusovy key of regulation of temperature.

Heating (defrosting of glasses)