| 1. Slightly fix a zamkovy element–1–nuts–2–. |
| 2. Slightly fix a bolt – 2–adjusting emphasis–1–below at lock facing. |
| 3. Unscrew tightening the screw-2-and extend an adjusting emphasis–3–a little. 1–rivet. |
4. Close a door of a back–4–and expose it moving in the longitudinal and cross-section direction so that to provide a uniform gap in relation to adjacent elements of a body. The lock of a door of a back should be fixed in a zamkovy element in the second position. The size of a gap is specified in Specifications. |
5. At performance of this operation an adjusting emphasis should be displaced in the correct situation. |
6. Open a door of a back and slightly tighten the moment of 2 N • m tightening the screw-2-. HUNDRED apply a dinamometrichesky screw-driver to achievement of the specified moment. |
7. Close a back door. |
| 8. Adjust an emphasis–1–from within with the help щупа so that their distance in relation to facing of an element of the lock made 1 mm. |
ATTENTION
Adjusting emphasis–1–at the closed door of a back should not adjoin to lock facing.
|
9. Tighten a bolt–2 – the moment of 8 N • m. |
10. Check a gap, address to Specifications. |