Replacement of elastic bands of brushes of screen wipers
At bad quality of purification of glass it is necessary to replace brushes of screen wipers. On sale are available as complete screen wipers (rubber with the holder), and separate brushes. If rubber is replaced only, watch to bending the holder.
ATTENTION If brushes move breakthroughs, as a rule, not enough to replace brushes or rubber. Just in case it is necessary to check and if necessary to adjust corner of installation of levers, thus address to the subsection Removal and installation, check and adjustment of final position of levers of a screen wiper.
REMOVAL
| PERFORMANCE ORDER |
| 1. Cast away up the lever, put a brush at right angle to the lever. |
| 2. Press a spring clip (And) (the arrow direction) and displace a brush down (In) from a hook on the lever. Unhook a lever brush. | | 3. Compress пассатижами both steel tires on the closed party of rubber and take out them from the top bracket. Then take out rubber completely with tires from the remained brackets of a brush. |
|
INSTALLATION
|
PERFORMANCE ORDER |
| 1. Enclose freely new rubber without tires in the bottom brackets of a brush. | | 2. Enter both tires into the first flute of rubber so that grooves of tires showed towards rubber and fix in rubber pads of a flute. | | 3. Compress both steel tires and rubber пассатижами and thus insert into the top bracket that bracket pads from both parties were fixed in tightening grooves (an arrow on an illustration) rubbers. | | 4. Insert rubber via the lever and fix spring brackets in lever hooks. A fairing on a brush if it is available, should look down. | | 5. Lower the lever back. Watch that rubber everywhere adjoined to glass, otherwise carefully turn in the holder. | |
| |
|
