Removal and installation of a beam of adjusting elements and loops of a back door
GENERAL INFORMATION
Back door, beam of adjusting elements
1–bolt, 30 N • m 2–door back 3–lining. It is established if necessary. Before removal write down quantity and thickness of linings. At assembly establish the same linings on the same place. 4–beam of adjusting elements
5–adjusting wedge. By moving of a wedge the door inclination around S.Regulirovka's rack can be changed is carried out by analogy to a forward door 6–bolt, 30 N • m 7–cable. Incorporates to the door lock.
Top loop of a door
1–the bolt, is established from within, 30 N • to m 2–door loop the top 3–cover, 23 N • m
4–bolt, 30 N • m 5–Torx screw, 30 N • m
Bottom loop of a door
1–loop bottom 2–door forward 3–bolt, 30 N • m
4–Torx screw, 30 N • m 5–bolt, 30 N • m
REMOVAL
PERFORMANCE ORDER
1. Remove door facing.
2. Turn out screws-1-and-5-.
3. Take out up a beam.
4. Disconnect a cable of blocking of a door.
5. Disconnect a casing at a rack In and расстыкуйте electric and pneumatic connections.
INSTALLATION
PERFORMANCE ORDER
1. Insert a beam into a door and slightly fix screws-1-and-6-and an adjusting wedge – 5–.
2. Tighten screws of fastening–1–and–6–in sequence and, b, c d.
3. Insert maple a door element. Adjust maple an element by analogy to a forward door.
